Product/Service

Portable Suface Roughness Tester SRG-1000

Source: Phase II Machine & Tool
The Phase II SRG-1000 surface roghness tester is a pocket-sized economically priced instrument for measuring surface texture conforming to traceable standards
The Phase II SRG-1000 surface roghness tester is a pocket-sized economically priced instrument for measuring surface texture conforming to traceable standards. It can be used on the shop floor in any position, horizontal, vertical or anywhere in between.

The large LCD disply shows either roughness parameter Ra or Rz at the touch of a button, combined withthe selected cutoff length. External calibration of the roughness values is possible by means of a special CAL button, which makes adjustment of this instrument very easy. A beep signal informs the user about each individual measurement status when ready.

The easy to use SRG-1000 operates on various surfaces, not only flat but also outer cylinder, outer cone, grooves and recesses greater than 80 x 30mm. The areas of application are wide spread. It is suitable for inspection departments, quality control, on the shop floor during machining, during assembly and on site.

The SRG-100 determines both roughness parameters Ra and Rz within a wide measuring range (see specifications below). The piezo-electric pick-up stylus with diamond tip assures a very reliable measurement within tolerances that conform to ISO class 3. Roughness parameter Ra is computed to conform to DIN.

Technical Specifications
Roughness Parameter
Ra (ISO), Rz (DIN)
Measuring Range
Ra: 0.05- 10.0 m / Rz 0.1-50 m
Cut-off lengths
0.0009in., 0.03in., 0.09in.
Filter
RC analogue
Tracing Length 0.23in (6mm)
Tracing Speed 0.04in/ Second (1.0mm/second)
Accuracy Conform ISO Class 3
Pick-up Stylus Piezo-electric
Tracer Tip Diamond, radius 10m + -2.5m
Operating Temperature 32-104 degrees F (0-40 degrees C)
Power 3.6v/2xNiMh batteries
Charger 9V DC
Contact force on probe <1.8ozf (<50gf)
Static measuring force of sensor stylus <0.06ozf (<1.6gf)
Dimensions 4.9 x 2.8 x 1.0in. (125 x 73 x 26mm)
Weight 0.4lbs (200g)

Phase II Machine & Tool, 283 Veterans Boulevard, Carlstadt, NJ 07072. Tel: 800-526-9087; Fax: 201-933-3801.