Product/Service

Height Gauge and Tightening Stand

Source: Techniks, Inc.
Save machine time and increase productivity by pre-setting tools offline.

Tighten and untighten the collet nut and pull stud and set the height of your tool all in one setup. Works for BT, CAT, ISO, HSK tool holders.

Height gauge can be ordered separately. A different fixture is used to secure holders with drive dog notches. Any 30 taper tool holder works with a 30 taper unit, just change the tightening device to accommodate each type of tool holder.

Accurate to .001" for height gauge.

Save machine time and increase productivity by pre-setting tools offline.

Tighten and untighten the collet nut and pull stud and set the height of your tool all in one setup. Works for BT, CAT, ISO, HSK tool holders.

Height gauge can be ordered separately. A different fixture is used to secure holders with drive dog notches. Any 30 taper tool holder works with a 30 taper unit, just change the tightening device to accommodate each type of tool holder.

Accurate to .001" for height gauge.

Techniks products are available exclusively through its distributors and are backed by a 100% satisfaction guarantee. Ask your distributor for a Techniks catalog or call (800) 597-3921 to find the distributor near you. For more information visit Techniks on-line catalog at: www.techniksusa.com

TECHNIKS – Built For Speed.

Techniks provides CAT, BT, and HSK tool holders and accessories throughout North America.