Hard Gage Calibration

Fox Valley Metrology uses state of the art equipment to ensure the highest degree of measurement uncertainty. With this equipment, and our custom-designed software, FVM is able to offer you the best possible turnaround time, and pricing in the industry. The hard gage calibration lab is held at 68°F with relative humidity not to exceed 45%. Both temperature and humidity are closely monitored by our Honeywell environmental control unit. We also have a suspended floor to help avoid unnecessary vibration and ensure a good measurement uncertainty of all of our equipment.

When your gages come into the hard gage lab, they have already been thoroughly cleaned and inspected for shipping damage. Gages sit in the lab for 24 hours in order to acclimate to our lab conditions. When the gages are calibrated, they are also closely inspected for nicks, burrs, and corrosion, re-cleaned and stickered. When packaged for return, gages are either coated in dip-seal, or oiled and wrapped in bubble wrap, and boxed securely. Calibration pricing includes cleaning, and level 4 certification. Currently, our average turnaround is 3-4 days.

FVM has the capability to handle hard gaging needs such as:

• Angle Gages
  
• Calibration Balls
  
• Cylindrical Rings and Plugs
  
• Cylindrical Squares
  
• Deltronic Plugs
  
• Feeler Gages
  
• Gage Blocks
  
• Gear Wires
  
• Kalmasters
  
• Length Standards
  
• Levels
  
• Mikemasters & Depth Mikemasters
  
• Optical Flats
  
• Parallels
  
• Pin Gages
  
• Protractors
  
• Radius Gages
  
• Screw Pitch Gages
  
• Spline Gages
  
• Squares
  
• Steel Rules and Tape Measures
  
• Taper Gages
  
• Taper Thread Gages (NPT,BSPT etc.)
  
• Thread Gages (standard, non-standard, Acme, British, Japanese, German, Buttress etc.)
  
• Thread Measuring Wires (UN, Acme, Buttress etc.)
  
• V-Blocks (repair & calibrate)

Fox Valley Metrology, 3125 Medalist Drive, Oshkosh, WI 54602. Tel: 920-426-5894; Fax: 920-426-8120.