26.00 Cable Probe
Source: M & H Inprocess USA, Inc.
For machining centers without automatic tool-changer
Probe uses:
For machining centers without automatic tool-changer
For machining centers without automatic tool-changer
Setting of workpiece zero points
Setting of workpiece alignment
Component size measurement
Compensation for temperature influence
Advantages:
Reduce set-up times
Production of constant high quality parts
Reduction of additional measuring requirements
Reduction of expensive pre-machining or fixturing
Replacement of all other probes
Product characteristics:
High speed probing
Break shaft technology
Automatic on / off switch
Stainless steel probe body
Microprocessor controlled
Lemosa connector with Helix cable
M & H Inprocess USA, Inc., 119 Chapel Hill Drive, Double Oak, TX 75077. Tel: 972-355-9199; Fax: 972-355-6416.